Users Guide

Table 26. TapeAlert flags supported by the Ultrium tape drive (continued)
Flag Number Flag Name Description Action Required
56 Unload failure Set when a drive hardware error
prevents the tape cartridge from
being unloaded from the tape
drive, or when the tape cartridge
is stuck in the drive.
1. Unload the cartridge from the
drive with the Operator Panel
or the Web User Interface.
2. Try a power cycle of the entire
library. This procedure causes
the drive to reset and attempt
to rewind and unload when
power is restored. If the
cartridge unloads, remove it
from the library and inspect it.
If damaged, discard it.
3. Try to unload the cartridge
from the drive again with the
Operator Panel or the Web
User Interface.
4. If the cartridge still does not
unload from the drive, see
“Contacting Dell technical
support” on page 111.
59 WORM Media
integrity check
failed
Set when the drive determines
that the data on the tape is
suspect from a WORM point of
view.
1. Copy the data to another
WORM tape cartridge.
2. Discard the old WORM tape.
60 WORM Media
overwrite
attempted
Set when the drive rejects a write
operation because the rules for
allowing WORM writes are not
met. Data is appended to WORM
media only. Overwrites to WORM
media are not allowed.
Append the information about a
WORM tape cartridge or write the
data to a non-WORM cartridge.
138 Dell PowerVault TL1000 Tape Autoloader: User's Guide