Users Guide

Table 29. Ultrium Tape drive sense data (continued)
Byte
Bit Address or Name
7 6 5 4 3 2 1 0
90-95 Reserved (0)
Table 30. Ultrium Tape drive sense data - Bytes 12 and 13
Byte 12 ASC Byte 13
ASCQ
Description
00 00 No additional sense - The flags in the sense data indicate the reason for the
command failure
00 01 Filemark detected - A Read or Space command terminated early due to an FM.
The FM flag is set.
00 02 EOM - A Write or Write File Marks command failed because the physical end of
tape was encountered, or a Read or Space command encountered EOM. The
EOM flag is set.
00 04 BOM - A space command ended at Beginning of Tape. The EOM bit is also set.
00 05 EOD - Read or Space command terminated early because End of Data was
encountered.
04 00 Cause not reportable - A cartridge is present in the drive, but it is in the process
of being unloaded.
04 01 Becoming Ready - A media access command was received during a front panel
initiated load or an immediate reported load command.
04 02 Initializing Command Required - A cartridge is present in the drive, but is not
logically loaded. A Load command is required.
04 03 Manual Intervention Required - A cartridge is present in the drive but could not
be loaded or unloaded without manual intervention.
0C 00 Write Error - A Write operation has failed. This is probably due to bad media, but
may be hardware related.
11 00 Unrecovered Read Error - A Read operation failed. This is probably due to bad
media, but may be hardware related.
11 12 Auxiliary memory read error. The drive reported that it is unable to read the
Auxiliary Memory in a WORM cartridge.
14 00 Recorded Entity Not Found - A space or Locate command failed because a
format violation prevented the target from being found.
14 03 End Of Data not found - A Read type operation failed because a format violation
related to a missing EOD data set.
14 10 Not Ready - Auxiliary memory not accessible. The drive is not able to become
ready because it is unable to access the Auxiliary Memory in a WORM cartridge.
1A 00 Parameter list length error - The amount of parameter data sent is incorrect.
20 00 Invalid Command Operation Code - The Operation Code in the command was not
a valid Operation Code.
24 00 Invalid eld in CDB - An invalid eld has been detected in a Command Descriptor
Block.
Appendix C. Sense data 143