Users Guide
Table 30. Ultrium Tape drive sense data - Bytes 12 and 13 (continued)
Byte 12 ASC Byte 13
ASCQ
Description
25 00 LUN not supported - The command was addressed to a non-existent logical unit
number.
26 00 Invalid Field in Parameter List - An invalid eld has been detected in the data
sent during the data phase.
27 00 Write Protect - A Write type operation has been requested on a cartridge which
has been write protected.
28 00 Not Ready to Ready Transition - A cartridge has been loaded successfully into
the drive and is now ready to be accessed.
29 00 Reset - The drive has powered on, received a reset signal or a bus device reset
signal since the initiator last accessed it.
2A 01 Mode Parameters Changed - The Mode parameters for the drive have been
changed by an initiator other than the one issuing the command.
30 00 Incompatible Media Installed - A write type operation could not be executed
because it is not supported on the cartridge type that is loaded.
30 01 Unknown Format - An operation could not be carried out because the cartridge in
the drive is of a format not supported by the drive.
30 02 Incompatible Format - An operation could not be completed because the Logical
Format is not correct.
30 03 Cleaning Cartridge Installed - An operation could not be carried out because the
cartridge in the drive is a cleaning cartridge.
30 07 Cleaning Failure - A cleaning operation was attempted, but could not be
completed for some reason.
30 0C Data Protect - WORM overwrite attempted. The drive rejected a write operation
because it would have resulted in an overwrite. Overwrite is not allowed on
WORM media.
30 0D Medium Error - WORM integrity check. The drive rejected a Read or Write
operation because the cartridge is a suspicious WORM cartridge.
31 00 Media format corrupted - Data could not be read because the format on tape is
not valid, but is a known format. A failure occurred attempting to write the FID.
37 00 Rounded parameter - A Mode Select command parameter has been rounded
because the drive can not store it with the accuracy of the command.
3A 00 Media Not Present - A media access command has been received when there is
no cartridge loaded.
3B 00 Sequential Positioning Error - A command has failed and left the logical position
at an unexpected location.
3D 00 Invalid bits in identify Message - An illegal Identify Message has been received at
the drive at the start of a command.
3E 00 Logical Unit has not Self-Congured - The drive has just powered on and has not
completed its self test sequence and can not process commands.
3F 01 Code Download - The rmware in the drive has just been changed by a Write
Buffer command.
40 xx Diagnostic failure - A diagnostic test has failed. The xx (ASCQ) is a vendor
specic code indicating the failing component.
144 Dell PowerVault TL1000 Tape Autoloader: User's Guide