Users Guide
Rear panel
45 1 2 6
3
a29z0003
Figure 5. Rear panel components
Table 4. Rear panel component descriptions
Number Component Description
1 Power connector The library connects to a 110/220 volt ac power supply.
2 Power switch The library is powered ON when the power supply switch on
the rear panel is ON (|). The library has no independent power
switch on the front panel.
3 SAS host interface
connector
Serial-attached SCSI host interface cable connection. The
Ultrium 4, 5, 6, and 7 SAS drives use the SFF-8088 connection
at the drive end and SFF-8088 or SFF-8470 at the host
adapter end.
4 Ethernet port This port is used to connect the library to a network.
5 Accessor locking screw The accessor locking screw is used to lock the accessor in
place during transportation.
Important: Remove the accessor locking screw before the
library is powered ON.
6 Air vent These vents allow air to escape from the power supply and
tape drive sled.
Bar code reader
The bar code reader is a part of the library accessor. The bar code reader reads each cartridge bar code
label that identies the types of cartridge magazines and tape drive that is installed in the library. It also
Chapter 1. Product description
5