Users Guide
Chapter 3. Installation and conguration
“Choosing a location” on page 21
“Acclimation” on page 22
“Installing in a rack” on page 22
“Removing the accessor locking screw” on page 28
“Attaching the library to a server” on page 28
“Conguring your library with the Web
User Interface” on page 32
“Logging in to the Web User Interface” on page 32
“Checking rmware level” on page 32
“Conguring library settings” on page 33
“Conguring network settings” on page 35
“Conguring date and time settings” on page 36
“Conguring encryption settings” on page 37
“Conguring email notications” on page 38
“Conguring trap notications” on page 39
“Managing user access” on page 42
“Saving the library conguration” on page 45
“Conguring your library with the
Operator Panel” on page 45
“Logging in to the Operator Panel” on page 46
“Conguring network settings” on page 46
“Conguring library settings” on page 47
“Populating the library with cartridges” on page 48
“Verifying library and drive operation” on page 50
“Taking the library online” on page 50
“Registering for support notication” on page 51
To install and congure a TL1000 Tape Autoloader, complete these procedures in the order they are
presented.
Choosing a location
Table 12. Location criteria
Criteria Denition
Room temperature 16 - 32 °C (60 - 90 °F)
Voltage 100 - 240 Vac. (4.0 to 1.5 A)
Note: The power switch is on the rear of the library
and must be easily accessible.
Frequency 50 - 60 Hz