Users Guide

a29z0023

Figure 26. The cables at the rear of the library

Note: For information about converting and relocating the library, see Chapter 8, “Removal and

replacement procedures,” on page 113.

Removing the accessor locking screw

Important: The accessor locking screw prevents the library accessor from moving during shipment and

must be removed before the library is powered ON.

Remove the accessor locking screw, located on the rear panel of the library ( 1 in Figure 27 on page 28).

a29z0102

Figure 27. accessor locking screw

Attaching the library to a server

The drive is attached to a server with the Serial Attached SCSI (SAS) interface. The Web User Interface

accesses the library with an ethernet interface.

Connecting the Host Interface cables

To connect the host interface cable to the library:

Note: It is recommended that you shut down and turn OFF the associated server before you connect the

SAS interface cable. Turn ON the associated server after the SAS interface cable is connected to the

library and server, the library is powered ON, and the library completed the initialization.

Dell PowerVault TL1000 Tape Autoloader: User's Guide