Users Guide
Table 13. Default library conguration settings (continued)
Conguration Item Default Setting
IPv6 address 0:0:0:0:0:0:0:0
Prex length 64
Gateway 0:0:0:0:0:0:0:0
DNS setting Disabled
DNS IP address 0.0.0.0
PHYSICAL
Library name (Blank)
Auto Cleaning Disabled
Bar code label length 8 characters
LOGICAL
Library mode Random
Loop Enabled
Auto Load Enabled
Active slots 9 + 0
ENCRYPTION (S4H and LATER ONLY)
Encryption method None
DATE and TIME
NTP server Disabled
NTP server address 0.0.0.0
Time zone (GMT) +00:00
Date (MM/DD/YYYY) 01/08/2008
Auto adjustment by PC Every 1 minute
NOTIFICATIONS
SMTP (mail) settings
Mail server address 0.0.0.0
Mail event Error events enabled
SNMP (trap) settings
Community Public
Trap event Error events enabled
SNMPv3 engine ID (Set by library rmware)
Static library network settings must be entered with the Operator Panel before the library can be
accessed remotely with the Web User Interface. If your system is serviced by a Dynamic Host
Conguration Protocol (DHCP) server, the network parameters are automatically set. Once remote access
is established, you can complete the conguration of your library remotely.
If you choose to use the Operator Panel to congure your library, go to “Conguring your library with the
Operator Panel” on page 45.
Chapter 3. Installation and
conguration 31