Users Guide
a. Select Congure Network Settings > Change Subnet Mask > Set Prex Length.
b. Enter the IPv4 prex length.
c. Press Enter again to apply the setting, or Cancel to reject the setting.
d. Press Cancel to backtrack through the menu hierarchy.
8. IPv4/IPv6 Gateway (Default: 0.0.0.0). If DHCP is disabled, set the IP address manually.
a. Select Congure Network Settings > Change Gateway.
b. Select Set Gateway Address IPv4 to enter the IPv4 gateway address or Set Gateway Address
IPv6 to enter the IPv6 gateway address (split over 4 screens).
c. Press Enter again to apply the setting, or Cancel to reject the setting.
d. Press Cancel to backtrack through the menu hierarchy.
9. Press Cancel to return to the Network Settings menu.
10. Press Cancel to return to the Conguration menu.
11. Press Cancel to return to the top menu screen.
Conguring library settings
To congure the library settings, complete the following procedure.
1. From the top menu screen, press the Minus key to select Conguration, and press Enter.
2. Select Congure Library, and press Enter.
3. Active Slots (Default: All)
a. Select Congure Library > Set Active Slots Count.
b. Select the number of active slots you would like to assign for the logical library.
c. To enable I/O station, select Active and I/O X Active + 1 I/O.
d. To disable I/O station, select Active and I/O X Active + 0 I/O.
e. Press Enter again to apply the setting, or Cancel to reject the setting.
4. Library Mode (Default: Random)
a. Select Congure Library > Congure Library Mode.
b. Select Set Random Mode or Congure Sequential Mode, and press Enter.
Random - In random mode, the library allows the server's (host's) application software to select
any data cartridge in any order.
Sequential - In sequential mode, the library's rmware predenes the selection of the cartridges.
After initialization, the rmware causes the library to select the rst available cartridge found
(counting from the lowest Column/Tier position through the highest cartridge position in your
library) for loading into the drive.
• Loop - Sequential mode with loop mode ON loads the cartridge in the lowest Column/Tier
cartridge position after the cartridge in the highest Column/Tier cartridge position is lled with
data and sent back to its home position. This procedure allows endless backup operations
without user interaction.
• Autoload - Sequential mode with autoload mode ON loads the rst available cartridge (the lowest
Column/Tier cartridge position that contains a cartridge) automatically if the library powers ON,
or resets, with an empty drive. If the library powers ON with a cartridge already in the drive,
sequential mode starts from the home position of that cartridge, unless the host issues a rewind
and unload command to the drive. In which case the next cartridge in sequence is loaded into the
drive.
To start sequential mode if autoload is OFF, use the Move Cartridge command to load the rst
cartridge into the drive. The sequence starts from the home position of that cartridge. Cartridges
need not to be in contiguous slots.
Chapter 3. Installation and
conguration 47