Users Guide
Congure the number of active slots with the following setting:
• Active Slots - The maximum number of active slots that can be set is dependent upon the I/O station
conguration and auto cleaning setting.
The active cartridge slots always begin with the cartridge position with the lowest cartridge address
within the logical library.
Conguring the library access mode
Configuration
ConfigureLibrary
ConfigureLibraryMode
SetRandomMode
SetSequentialMode
ConfigureLoopMode
EnableLoopMode
DisableLoopMode
Configure AutoloadMode
Enable AutoloadMode
Disable AutoloadMode
Figure 66. Library access mode settings
Select Conguration > Congure Library > Congure Library Mode to set the logical library access
mode.
Congure the library access mode with the following settings:
• Random Mode - In random mode, the library allows the server's (host's) application software to select
any data cartridge in any order.
• Sequential Mode - In sequential mode, the library's rmware predenes the selection of the cartridges.
After initialization, the rmware causes the library to select the rst available cartridge found (counting
from the lowest Column/Tier position through the highest cartridge position in your library) for loading
into the drive.
– Loop - Sequential mode with loop mode ON loads the cartridge in the lowest Column/Tier cartridge
position after the cartridge in the highest Column/Tier cartridge position is lled with data and sent
back to its home position. This mode allows endless backup operations without user interaction.
– Autoload - Sequential mode with autoload mode ON loads the rst available cartridge (the lowest
Column/Tier cartridge position that contains a cartridge) automatically if the library powers ON, or
resets, with an empty drive. If the library powers ON with a cartridge already in the drive, sequential
mode will start from the home position of that cartridge, unless the host issues a rewind and unload
command to the drive, in which case the next cartridge in sequence will be loaded into the drive.
To start sequential mode if autoload is OFF, use the Move Cartridge command to load the rst
cartridge into the drive. The sequence starts from the home position of that cartridge. Cartridges do not
need to be in contiguous slots.
To stop sequential mode, use the Move Cartridge command to unload the drive. This mode cancels
sequential mode; the next sequential cartridge is NOT loaded.
To restart sequential mode, use the Move Cartridge command again to load a cartridge; the loading
sequence resumes from the home position of that cartridge.
Chapter 4. Operations
59