Users Guide

Note: The Internet Protocol (IPv4, IPv6, or dual IPv4/IPv6) selection is used for the TL1000 Tape

Autoloader IP address, subnet mask, gateway address, time server address, mail server address, SNMP

trap address, and EKM server addresses.

Congure the network with the following settings:

• Link Speed - Ethernet duplex mode (Auto, 10Base-T Full, 10Base-T Half, 100Base-TX Full, 100Base-

TX Half).

• DHCP - (Dynamic Host Conguration Protocol) Enable DHCP to have the library server or router

negotiate the connection with the library.

– IPv4 - Select to enable DHCP with the IPv4 protocol.

– IPv6 - Select to enable DHCP with the IPv6 protocol

• IP Address - If DHCP is disabled, set the IP address of the library manually.

– IPv4 - Select to enter the library IP address with the IPv4 protocol.

– IPv6 - Select to enter four library IP addresses with the IPv6 protocol.

• Subnet Mask - If DHCP is disabled, set the IP address of the subnet mask.

– Subnet Mask - Select to enter the subnet mask address with the IPv4 protocol.

– Prex Length - Select to enter the prex length for the IPv6 protocol.

• Gateway - If DHCP is disabled, set the IP address of the gateway.

– IPv4 - Select to enter the gateway IP address with the IPv4 protocol.

– IPv6 - Select to enter four gateway IP addresses with the IPv6 protocol.

Conguring Operator Panel settings

Configuration

ConfigureOpPanelSettings

ConfigureLCDBackLight

Enable AutoBackLight

InputCount(min)

Disable AutoBackLight

ChangeLoginPassword

NewPassword

ReenterPassword

Figure 69. Operator Panel settings

Select Conguration > Congure Op Panel Settings to set the preferences when with the Operator

Panel.

Congure the Operator Panel with the following settings:

• Back light - Select to enable the LCD back light when with the Operator Panel.

– Input Count - If the auto back light is enabled, specify the time duration before the back light turns

OFF. The setting uses a four-digit timer in minutes.

• Login Password - Select to change the Operator Panel four-character login password. The new

password must be reentered for conrmation before the password is changed (default: 0000).

Chapter 4. Operations