Users Guide

Conguring network settings

Figure 90. Network settings screen

Use Congure Library > Network to set the network settings for the library.

Note: The Internet Protocol (IPv4, IPv6, or dual IPv4/IPv6) selection is used for the TL1000 Tape

Autoloader IP address, subnet mask, gateway address, time server address, mail server address, SNMP

trap address, and EKM server addresses.

Congure the network with the following settings:

• Ethernet - Select link speed duplex mode (Auto, 10Base-T Full, 10Base-T Half, 100Base-TX Full,

100Base-TX Half).

• Security - Select Enable SSL for Web to provide secure communications between the web browser and

the tape library.

• TCP/IP settings - IPv4, IPv6, and dual stack IPv4/IPv6 are supported. To enable the dual IPv4/IPv6

protocol, select both Use IPv4 and Use IPv6 and enter parameters for both.

• IPv4 Settings - Select Use IPv4 to enable the IPv4 Internet Protocol. Select the corresponding option

to obtain an IP address automatically (DHCP) or use static IP address settings. When with DHCP, use

the Operator Panel to determine the library IP address. See “Current information” on page 54. Enter the

following parameters if you are using static IP address settings.

– IPv4 address - Sets the TCP/IPv4 address of the library on the network.

– Subnet mask - Denes and limits users within a local network.

Dell PowerVault TL1000 Tape Autoloader: User's Guide