Users Guide

To modify the network settings:
1. In the Configure Library menu in the left navigation pane of the Web User Interface, click Network.
2. Select the Ethernet Link speed (duplex mode).
3. In Security, select Enable SSL for Web to provide secure communications between the web browser
and the tape library.
4. Select the TCP/IP settings. To enable dual IPv4/IPv6 protocol, select both Use IPv4 and Use IPv6 and
enter parameters for both.
v IPv4 settings - Select Use IPv4 to enable the IPv4 Internet Protocol. Select the corresponding button
to obtain an IP address automatically (DHCP) or use static IP address settings. When with DHCP,
use the Operator Panel to determine the library's assigned IP address. See “Configuring network
settings” on page 63. Enter the following parameters if Use static IP address is selected.
– IPv4 address - Sets the TCP/IPv4 address of the library on the network.
– Subnet mask - Defines and limits users within a local network.
– Gateway - Allows access outside the local network.
Figure 33. Network settings
36 Dell PowerVault TL1000 Tape Autoloader: User's Guide