Users Guide
4. Push the drive sled slowly into the drive slot until the sled seats itself against the back of the library.
5. Tighten the captive thumbscrews (▌7▐ in Figure 141 on page 182) until the drive sled is secure.
6. If you are installing a drive sled without ESD springs (see Figure 139 on page 181), apply conductive
tape to the sled as shown in Figure 144.
a77ug028
Figure 143. Pushing the drive sled into the library (drive sled without ESD springs shown)
2ULibrary 4ULibrary
a77ug203
Figure 144. Diagrams for applying conductive tape for ESD protection to the back of a drive sled installed in a 2U or
4U library
184 Dell PowerVault TL2000 Tape Library and TL4000 Tape Library: User's Guide