Users Guide

Note: The small gray markers show where conductive tape should be placed to provide ESD
protection.
5. Install cover plates on any open drive slots in the library.
6. Power ON the library.
7. Run the Library Verify test. (Operator Control Panel: Service > Library Verify). This test requires the
use of a scratch (blank) cartridge.
v If the test passes:
– When prompted by the Operator Control Panel display and the I/O Station opens, remove the
cartridge used in the test.
– Press Cancel to exit the Library Verify screen.
– Proceed to “Configuring the Tape Drive.”
v If the test fails, an error code will be displayed. Make note of the error, then refer to the
Troubleshooting chapter in the Dell PowerVault TL2000 Tape Library and TL4000 Tape Library User's
Guide for additional instructions.
Configuring the Tape Drive
1. Log on to the Web User Interface.
2. Verify that you are running the latest versions of Library and Drive firmware. Upgrade the firmware
at Service Library > Upgrade Firmware.
3. Use the Web UI to update the Logical Library (Configure Library > Logical Libraries) and Drive
(Configure Library > Drives) configurations. Refer to “Operations” on page 75. Select Submit on the
Configure Library > Logical Libraries web page even if there are no required changes. This action
will refresh the Data Transfer Element (DTE) for the drives. Refer to Appendix A, “SCSI Element
Types, SCSI Addresses, and Physical Configurations,” on page 203 for information regarding DTE
addressing. If Configure Library > Logical Libraries does not correctly refresh/update the DTE
addresses, execute step 3 and step 4. Otherwise, proceed to Step 5.
4. Reconfigure your library using the OCP to configure your network settings, then using the Web UI to
complete your library configuration.
5. Save your library configuration to your host computer or to a USB device.
6. Update your Library Configuration Form with the new drive and configuration information.
7. Resume normal library operations.
Replacing a Power Supply
1. Power OFF the library by pressing and holding down the power button for 4 seconds.
2. Disconnect the power cord from the electrical source, then from the library.
3. Loosen the three blue captive thumbscrews on the power supply located on the back panel of the
library.
4. Pull on two of the thumbscrews to pull the unit away from the rear panel of the library, then grasp
the top and bottom edge of the power supply and pull it out of the library.
186 Dell PowerVault TL2000 Tape Library and TL4000 Tape Library: User's Guide