Users Guide

Note: User and Superuser accounts must be enabled by the library administrator. These accounts are
disabled by default.
Note: Passwords are case-sensitive.
Use the following password for logging in as an Admin user: secure
Each level affects which areas you have access to and what actions you can initiate from those areas.
For DHCP, use the Operator Control Panel to determine the IP Address assigned to your library. Navigate
to Monitor > Library > Identity. Scroll down to IP Address and make note of the address. Enter the IP
Address in your internet browser address field to access your library with the Web User Interface.
For IPv4 or Dual Stack IPv4 + IPv6, enter your library's static IP Address using the 0.0.0.0 format (four
octets).
For IPv6, enter your library's static IP Address or Router Assigned IP Address using the following format:
http://[0:0:0:0:0:0:0:0]. To determine your Router Assigned IP Address, navigate to Monitor > Library >
Network on the Operator Control Panel.
If the dual IP stack is enabled (IPv4 + IPv6), IPv6 addresses cannot be configured in the OCP (Operator
Control Panel) and must be configured through the Web User Interface. IPv6 addresses can only be
configured in the OCP if the IPv6-only stack is enabled. In the case where the dual stack is enabled, the
IPv6 address must be configured through the web interface (either using the IPv4 address or a known
other IPv6 address).
System Status
The System Status screen is always present after login giving current status of the library.
a77ug070
Figure 9. Web User Interface login page
a77ug080
Figure 10. 2U library System Status screen
User Interfaces 21