Users Guide

If you choose Dual Stack IPv4 & IPv6, you must be prepared to enter both IPv4 and IPv6 IP
addresses. The sections below will gray out depending on the choices made here.
3. Enter the Host Name.
Note: The underscore (_) is not allowed as part of a host name.
4. Enter the Domain Name.
5. DNS Primary - Enter the IP address of your primary DNS server.
6. DNS Secondary - Enter the IP address of your secondary DNS server.
7. Enable SSL for Web - If you desire to have SSL (Secure Sockets Layer) enabled, place a check in this
box.
Note: If you get a security certificate alert when logging in to the Web User Interface, you can install
the certificate or allow an exception (depending on the internet browser you are using). SSL is
enabled when the URL begins with https:// and some browsers will show a lock.
8. Ethernet Settings - Ethernet Settings choices are: Auto (the default), 10 Mbit/Half, 10 Mbit/Full, 100
Mbit/Half, 100 Mbit/Full. Please refer to www.Dell.com/support to determine the availability of
manual Ethernet settings in your library's firmware.
9. Enter IPv4 settings (if applicable).
a. Enable DHCP - Click this item ON to have the IP Address of your library automatically set by
the DHCP server.
b. Static Address - Enter the assigned IPv4 address. The format of an IPv4 IP address is a 32-bit
numeric address written as four numbers separated by periods.
c. Network Mask - Enter the assigned IPv4 Network Mask.
d. Gateway address - Enter the assigned IPv4 Gateway address. This address allows access outside
the local network.
10. Enter IPv6 settings (if applicable).
a. Enable DHCP - Click this item ON to have the IP Address of your library automatically set by
the DHCP server.
b. Enable Stateless Auto Config - Stateless Auto config is ALWAYS on (not defeatable).
c. Static Address - Enter the assigned IPv6 address. The format of an IPv6 IP address is a 128-bit
numeric address written as 8 groups of four numbers separated by colons.
d. Prefix length - The default prefix length is set to 64, but can be set to any length, depending
upon the address used.
e. Gateway address - Enter the assigned IPv6 Gateway address. This address allows access outside
the local network.
11. Click one of the following:
v Refresh - to cancel the changes made to the screen.
v Submit - to apply the changes made to the screen.
Note: Depending on the changes made, you will either be disconnected and need to login again, or
reboot the library. If a reboot is required, the following Warning message will appear after the
Submit button is clicked.
The library must be rebooted or the changes will not take place.
Figure 51. Warning Screen
Installation and Configuration 63