Users Guide

Entering Email Notification Information using the Web User Interface
This function is not available on the Operator Control Panel.
Use this menu item to set up email notification of library errors and warnings.
1. Click Configure Library > Email Notification in the left navigation pane.
2. If you would like to be notified when an error occurs, select Notify Errors.
3. If you would like to be notified when a warning occurs, select Notify Warnings.
4. In To Email Address, enter the email address to which the information will be sent.
5. In SMTP Server Address (IPv4 or IPv6), enter the IP Address of the SMTP server associated with the
email address.
6. Enter the Domain Name for your library. This field cannot be blank when using event notification.
Note: If you attempt to enter a blank value for the Domain Name, a warning message will appear. It
will say If you are using Event Notification then a value is required for the Domain Name.
7. Click one of the following:
v Refresh - to cancel all of your entries and leave the settings as they were.
v Submit - to apply the changes made to the screen.
Configuring SNMP settings
This page shows the current SNMP configuration of the library and allows modification to the
configuration. When a change is requested, a box checks to confirm the changes.
Click SNMP in the left navigation pane to display the SNMP page.
a77ug065
Figure 55. The Configure Library: Email Notification screen
66 Dell PowerVault TL2000 Tape Library and TL4000 Tape Library: User's Guide