System information


1. Follow the instructions in "Preparing to Work Inside the Computer."
2. Remove the keyboard.
3. Remove the display bezel.
4. Remove the two M2 x 3-mm screws from each side of the display panel, and remove the display side brackets.



5. Remove the two M2 x 5-mm screws from each side of the display panel.
6. Unsnap the cable from the top cover hook, and lift the bracket out of the display assembly.
7. Lift the display panel, and rotate the display panel out of the top cover.
8. Use the pull-tab to disconnect the bottom flex-cable connector from the inverter connector.


CAUTION: Before performing the following procedures, read the safety instructions in your System Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer.
NOTE: When you replace the display side brackets, ensure that the tabs on the brackets are facing up.
1
display panel
See MINI RSL
2
display side brackets (2)
8T145
3
M2 x 3-mm screws (4)
4270E
1
top flex-cable connector
6M871 (flex cable, flex-cable connector,