System information

Back to Contents Page

Palm Rest
Dell™Latitude™D600ServiceManual



1. Follow the instructions in "Preparing to Work Inside the Computer."
2. Remove the keyboard.

3. Remove the display assembly.
4. Remove the three M2 x 3-mm screws labeled "circle P" from the top of the palm rest.


5. Disconnect the touch pad connector from the system board.

CAUTION: Before performing the following procedures, read the safety instructions in your System Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
NOTICE: You must remove the display assembly before you remove the palm rest; the display hinges pass through the back of the palm rest.
1
M2 x 3-mm screws (3)
4270E
2
top of the palm rest
