Owners Manual

Steps

1. Connect the optical-drive data and power cable to the connectors on the optical-drive and flip the hard-disk drive and optical-disk

drive module.

2. Insert the tabs on the hard-disk drive and optical-disk drive module into the slot on the system at an angle.

3. Lower the hard-disk drive and optical-disk drive module into the slot.

4. Slide the release latch to lock the hard-disk drive and optical-disk drive module.

5. Reroute the hard-disk drive power cable and SATA cable through the retention clips on the hard-disk drive and optical-disk drive

module.

6. Reroute the hard-disk drive power cable and the SATA cable through the recess on the release tab.

Next steps

1. Install the Front bezel

2. Install the Side cover

3. Follow the procedure in After working inside your computer.

Disassembly and reassembly