Owners Manual

NOTE: This step is applicable only for a 6-cell battery

5 Unroute the cable from the routing channel [1] and remove the cable from the battery [2].

NOTE: This step is applicable only for a 4-cell battery.

Installing the battery

NOTE

: If your computer supports a 6-cell battery, it will not support a hard drive.

1 Connect the battery cable to the connector on the battery.

2 Route the battery cable through the routing channel on the battery.

NOTE

: This step is applicable only for a 4-cell battery.

3 Insert the battery into the slot on the computer.

4 Tighten the screws to secure the battery to the computer.

5 Connect the battery cable to the connector on the system board.

6 Install the base cover.

7 Follow the procedure in After working inside your computer.

Removing the hard drive assembly

If the system is shipped with hard drive assembly perform the following steps.

1 Follow the procedure in Before working inside your computer.

2 Remove the:

a base cover

b battery

3 To remove the hard drive assembly:

a Disconnect the hard drive cable from the connector on the system board [1] .

b Remove the screws that secure the hard drive assembly to the computer [2].

c Lift the hard drive assembly away from the computer [3].

Removing and installing components