Owners Manual
Table Of Contents
- Precision 3640 Tower Service Manual
- Working on your computer
- Technology and components
- Major components of your system
- Disassembly and reassembly
- Recommended tools
- Screw list
- Chassis rubber feet
- Cover
- SD card—optional
- Bezel
- Hard drive
- PSU hinge
- Graphics card
- Memory module
- Speaker
- Coin cell battery
- Power supply unit
- Optical drive
- WLAN module and SMA antenna
- IO panel
- Solid state drive
- Power button module
- Heatsink assembly
- Voltage regulator heat sink
- Front fan
- System fan
- Optional IO card
- Processor
- Intrusion switch
- System board
- Troubleshooting
- Getting help and contacting Dell
- Cable cover
- Dust filter
Cable cover
The cable cover for Precision Tower 3640 helps protect ports and cables connected to the system.
About this task
Follow these steps to install the cable cover on the system chassis.
NOTE: Images shown below are for representation only and may vary depending on the system's configuration.
Steps
1. Insert the tab on the security-lock metal bracket into the slot on the rear side of the system [1] and rotate to align the holes
on the metal bracket with screw holders on the chassis [2]
2. Fasten the two #6-32x1/4'' screws to secure the security metal bracket to the chassis [3].
3. Pull the cable release latch and lift the latch away from the cable cover.
A
Cable cover 107