Owners Manual
Table Of Contents
- Precision 3640 Tower Service Manual
- Working on your computer
- Technology and components
- Major components of your system
- Disassembly and reassembly
- Recommended tools
- Screw list
- Chassis rubber feet
- Cover
- SD card—optional
- Bezel
- Hard drive
- PSU hinge
- Graphics card
- Memory module
- Speaker
- Coin cell battery
- Power supply unit
- Optical drive
- WLAN module and SMA antenna
- IO panel
- Solid state drive
- Power button module
- Heatsink assembly
- Voltage regulator heat sink
- Front fan
- System fan
- Optional IO card
- Processor
- Intrusion switch
- System board
- Troubleshooting
- Getting help and contacting Dell
- Cable cover
- Dust filter
8. Flex the hard drive bracket [1], lift the hard drive [2], and then slide out from the hard drive bracket [3].
NOTE: Follow the same procedure to remove another hard drive on the other side of the bracket.
Installing the 2.5-inch hard drive
Steps
1. Insert the holes on one side of the hard disk into the pins on the hard drive bracket [1], and then place the hard drive into the
bracket such that the pins on other side of the bracket is aligned with the holes on the hard drive [2].
NOTE: Follow the same procedure to install another hard drive on the other side of the bracket.
Disassembly and reassembly 29