Owners Manual
Table Of Contents
- Precision 3640 Tower Service Manual
- Working on your computer
- Technology and components
- Major components of your system
- Disassembly and reassembly
- Recommended tools
- Screw list
- Chassis rubber feet
- Cover
- SD card—optional
- Bezel
- Hard drive
- PSU hinge
- Graphics card
- Memory module
- Speaker
- Coin cell battery
- Power supply unit
- Optical drive
- WLAN module and SMA antenna
- IO panel
- Solid state drive
- Power button module
- Heatsink assembly
- Voltage regulator heat sink
- Front fan
- System fan
- Optional IO card
- Processor
- Intrusion switch
- System board
- Troubleshooting
- Getting help and contacting Dell
- Cable cover
- Dust filter
Installing heatsink assembly - 65 W or 80 W CPU
About this task
These steps applies to system configurations shipped with 65 W or 80 W CPU.
Steps
1. Align the heat sink assembly with the screw holders on the system board and place it on the processor [1].
2. Tighten the 4 captive screws to secure the heat sink assembly to the system board [2].
NOTE: Tighten the screws in a sequential order (1,2,3,4) as mentioned on the system board.
3. Connect the heat sink assembly cable to the connector on the system board [3].
Disassembly and reassembly
71