Owners Manual
Table Of Contents
- Working inside your computer
- Disassembly and reassembly
- Recommended tools
- Screw List
- Major components of your system
- Side cover
- Power-supply unit cage
- Front bezel
- Memory modules
- Solid-state drive
- 2.5-inch hard drive
- 3.5-inch hard drive
- WLAN card
- Slim optical-drive
- Graphics card
- System fan
- Coin-cell battery
- Processor fan and heat-sink assembly
- Processor
- Power button
- Intrusion switch
- Front I/O panel
- System board
- Drivers and downloads
- System setup
- Troubleshooting
- Getting help and contacting Dell
Steps
1. Position the system fan to align it with the slots on the computer chassis.
2. Replace the single (#6-32) screw that secures the system fan to the computer chassis.
Next steps
1. Close the PSU cage
2. Install the side cover.
3. Follow the procedure in after working inside your computer.
Coin-cell battery
Removing the coin-cell battery
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Open the PSU cage.
4. Remove the powered GPU.
NOTE: This step is required only if the system is configured with powered GPU.
About this task
The following images indicate the location of the coin-cell battery and provide a visual representation of the removal procedure.
Disassembly and reassembly
33