Owners Manual

Next steps
1. Install the processor fan and heat-sink assembly.
2. Close the PSU cage
3. Install the side cover.
4. Follow the procedure in after working inside your computer.
Power button
Removing the power button
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Open the PSU cage.
4. Remove the front bezel.
About this task
The following images indicate the location of the power button and provide a visual representation of the removal procedure.
Steps
1. Disconnect the power-button cable from the connector on the system board.
2. Press the release tabs on the power-button head and slide the power-button cable out from the front-side chassis of the
computer.
3. Pull the power-button cable out from the computer.
Installing the power button
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the power button switch and provide a visual representation of the installation
procedure.
Steps
1. Insert the power-button cable into the slot from the front-side of the computer, and press the power-button head until it
clicks into the place in the chassis.
2. Align and connect the power-button cable to the connector on the system board.
Next steps
1. Install the front bezel.
2. Close the PSU cage
3. Install the side cover.
4. Follow the procedure in after working inside your computer.
Disassembly and reassembly
39