Owners Manual
Table Of Contents
- Working inside your computer
- Disassembly and reassembly
- Recommended tools
- Screw List
- Major components of your system
- Side cover
- Power-supply unit cage
- Front bezel
- Memory modules
- Solid-state drive
- 2.5-inch hard drive
- 3.5-inch hard drive
- WLAN card
- Slim optical-drive
- Graphics card
- System fan
- Coin-cell battery
- Processor fan and heat-sink assembly
- Processor
- Power button
- Intrusion switch
- Front I/O panel
- System board
- Drivers and downloads
- System setup
- Troubleshooting
- Getting help and contacting Dell
Intrusion switch
Removing the intrusion switch
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Open the PSU cage.
About this task
The following image indicates the location of the intrusion switch and provides a visual representation of the removal procedure.
Steps
1. Disconnect the intruder cable from the connector on the system board.
2. Slide and remove the intrusion switch from the chassis.
Installing the intrusion switch
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the intrusion switch and provides a visual representation of the installation
procedure.
40
Disassembly and reassembly