Owners Manual
Table Of Contents
- Working inside your computer
- Disassembly and reassembly
- Recommended tools
- Screw List
- Major components of your system
- Side cover
- Power-supply unit cage
- Front bezel
- Memory modules
- Solid-state drive
- 2.5-inch hard drive
- 3.5-inch hard drive
- WLAN card
- Slim optical-drive
- Graphics card
- System fan
- Coin-cell battery
- Processor fan and heat-sink assembly
- Processor
- Power button
- Intrusion switch
- Front I/O panel
- System board
- Drivers and downloads
- System setup
- Troubleshooting
- Getting help and contacting Dell
Steps
1. Disconnect all the cables that are connected to the system board.
2. Remove the eight (#6-32) screws that secure the system board to the chassis.
3. Lift the system board at an angle and remove the system board off the chassis.
Installing the system board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the system board and provide a visual representation of the installation procedure.
Disassembly and reassembly 47