User's Manual

Diskettesubsystemresetfailed— Dell Diagnostics (see Dell Diagnostics).

Diskettewriteprotected— Slide the write-protect notch to the open position.

Drivenotready— Put a floppy disk in the drive.

GateA20failure— See Lockups and Software Problems.

Hard-diskconfigurationerror— 

Hard-diskcontrollerfailure— 

Hard-diskdrivefailure— 

Hard-diskdrivefailure— 
See Drive Problems.

Insertbootablemedia— Insert a bootable floppy disk or CD.

Invalid configuration information -pleaserunSETUPprogram— Enter system setup (see Entering System Setup) and correct the
computer configuration information.

Keyboardfailure— See Keyboard Problems.

Memory address line failure at address, read value expecting value — See Lockups and Software Problems.

Memoryallocationerror— 
1. Turn off the computer, wait 30 seconds, and then restart the computer.
2. Try to run the program again.
3. If the error message appears again, see the software documentation for additional troubleshooting suggestions.

Memory data line failure at address, read value expecting value — 

Memory double word logic failure at address, read value expecting value — 

Memory odd/even logic failure at address, read value expecting value — 

Memory write/read failure at address, read value expecting value — 

MemorysizeinCMOSinvalid— 
See Lockups and Software Problems.

Nobootdeviceavailable— 
l If the floppy drive is your boot device, ensure that a bootable floppy disk is in the drive.
l If the hard drive is your boot device, ensure that the cables are connected and that the drive is installed properly and partitioned as a
boot device.
l Enter system setup (see Entering System Setup) and ensure that the boot sequence information is correct.

No boot sector on hard-diskdrive— Enter system setup (see Entering System Setup) and ensure that the computer configuration
information for the hard drive is correct.