User's Manual


6. Connect a power cable to the hard drive and to the power supply.

7. Connect the serial ATA cable to the back of the drive and to the SATA3 connector on the system board.

Installing an Additional Fan



1
sliding-plate
lever
2
hard-drive holder with hard drive

NOTE: The optional third hard drive is located in the lower 5.25-inch
drive bay for desktop computers.
1
power cable
2
power supply
3
serial ATA
cable
4
SATA3
connector
5
optional serial ATA hard drive (desktop illustrated)

NOTE: The optional third hard drive is located in the
lower 5.25-inch drive bay for desktop computers.


CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before opening the cover.
CAUTION: For configurations with three SAS hard drives, you must install an additional fan. See Installing an Additional Fan.
NOTICE: To avoid damage to the drive, do not set it on a hard surface. Instead, set the drive on a surface, such as a foam pad, that will sufficiently
cushion it.