Connecting to PCoIP Remote Access Host Cards in Dell Precision Host Workstations Quick Reference Guide 1.0 December 2020 Rev.
Notes, cautions, and warnings NOTE: A NOTE indicates important information that helps you make better use of your product. CAUTION: A CAUTION indicates either potential damage to hardware or loss of data and tells you how to avoid the problem. WARNING: A WARNING indicates a potential for property damage, personal injury, or death. © 2015 -2020 Dell Inc. or its subsidiaries. All rights reserved. Dell, EMC, and other trademarks are trademarks of Dell Inc. or its subsidiaries.
Contents Chapter 1: Dell Precision Workstations with PCoIP Zero Clients.................................................... 4 Chapter 2: Installing the Remote Access Host Card.......................................................................5 Chapter 3: Connecting the Cables ................................................................................................ 6 Chapter 4: Configuring the Remote Access Host Card...................................................................
1 Dell Precision Workstations with PCoIP Zero Clients 1:1 Remote access from anywhere 1. 2. 3. 4. 5. 6.
2 Installing the Remote Access Host Card ● If you purchased a Dell Precision workstation with a PCoIP remote access host card, the host card is already installed in your Dell Precision workstation host computer. Skip to the topic : Connect the Cables ● If you purchased a customer install kit, Install the host card in your Dell Precision workstation host computer.
3 Connecting the Cables Figure 1. 1. 2. 3. 4. 5. 6. Host card Graphics card Precision Rack Workstation Wyse or Amulet Hotkey DXZ4 PCoIP Zero Client Dell Management Computer (PC) External switch To Connect the cables: 1. Connect one or two of the Mini DisplayPort to Display port cables between the host card and the graphics card. 2. Connect a Category 5e cable from the host card to a port on your Ethernet switch. 3.
4 Configuring the Remote Access Host Card To configure the host card: 1. Shut down and restart the management computer 2. On the management computer, go to Network Settings and configure the IP address to: ● Address: 192.168.1.200 ● Subnet Mask: 255.255.0.0 NOTE: Parameters such as Gateway and DNS may be left blank. 3. Shut down and restart the Precision Host Workstation computer, and wait for a minute (first time only delay for DHCP timeout) before moving to the next step. 4.
5 Configuring the Wyse or Amulet DXZ4 PCoIP Zero Client To configure the Wyse or Amulet DXZ4 PCoIP Zero Client: NOTE: You will need the MAC address, IP address, and Subnet Mask address of the host card when you configure the Wyse or Amulet DXZ4 PCoIP Zero Client. 1. Connect the AC adapter to the Wyse or Amulet DXZ4 PCoIP Zero Client and turn it on. 2. On the management computer, launch the Web browser and type 192.168.1.50 . 3.
6 Contacting Dell NOTE: Dell provides hardware (break/fix) support only for Remote Access Host cards and Wyse Zero Clients. Downloads and Tech Support for Teradici firmware and software offerings are solely provided by Teradici at Teradici.com.