Setup Guide
Table Of Contents
- Connecting to PCoIP Remote Access Host Cards in Dell Precision Host Workstations Quick Reference Guide
- Dell Precision Workstations with PCoIP Zero Clients
- Installing the Remote Access Host Card
- Connecting the Cables
- Configuring the Remote Access Host Card
- Configuring the Wyse or Amulet DXZ4 PCoIP Zero Client
- Contacting Dell
Connecting the Cables
Figure 1.
1. Host card
2. Graphics card
3. Precision Rack Workstation
4. Wyse or Amulet Hotkey DXZ4 PCoIP Zero Client
5. Dell Management Computer (PC)
6. External switch
To Connect the cables:
1. Connect one or two of the Mini DisplayPort to Display port cables between the host card and the graphics card.
2. Connect a Category 5e cable from the host card to a port on your Ethernet switch.
3. Connect a Category 5e cable from the Wyse or Amulet Hotkey DXZ4 Zero client to a port on the Ethernet switch. Note:
There are two network ports on the DXZ4 Zero client. Only one port needs to be used.
4. Connect a Category 5e cable from the management computer (desktop or notebook on the network with a network card) to
a port on the Ethernet switch.
3
6 Connecting the Cables