Users Guide
Installing System Board Options 9-5
,QVHUW WKH H[SDQVLRQ FDUG LQWR WKH H[SDQVLRQFDUG FRQQHFWRU
If the expansion card is full-length, insert the front end of the card into the corre-
sponding card guide on the inside front of the chassis as you insert the card into
its connector.
Insert the card’s edge connector firmly into the expansion-card slot. Gently rock
the card into the connector until it is fully seated (see Figure 9-4).
)LJXUH ,QVWDOOLQJ DQ ([SDQVLRQ &DUG
:KHQ WKH FDUG LV ILUPO\ VHDWHG LQ WKH FRQQHFWRU VHFXUH WKH FDUG·V
PRXQWLQJ EUDFNHW WR WKH FKDVVLV ZLWK WKH VFUHZ \RX UHPRYHG LQ VWHS
&RQQHFW DQ\ FDEOHV WKDW VKRXOG EH DWWDFKHG WR WKH FDUG
See the documentation that came with the card for information about the card’s
cable connections.
5 HSOD FH WKH F RPS XWHU F RYHU DQG UHFRQQHF W \RXU FRPSXWHU DQG SHULSK
HUD OV WR WKHLU SRZHU VRXUFHV DQG WXUQ WKHP RQ
NOTE: After you remove and replace the cover, the chassis intrusion detector will
cause the following message to be displayed at the next system start-up:
ALERT! Cover was previously removed.
7R UHVHW WKH FKDVVLV LQWUXVLRQ GHWHFWRU HQWHU WKH 6\VWHP 6HWXS SURJUDP
DQG UHVHW &KDVVLV ,QWUXVLRQ WR 1RW 'HWHFWHG
See Chapter 3, “Using the System Setup Program,” for instructions.
expansion card
card-edge
connector
expansion-card
connector
23205BK0.BK : 23205C90.FM Page 5 Wednesday, March 18, 1998 1:51 PM
Downloaded from www.Manualslib.com manuals search engine