Users Guide
Installing Drives 10-3
)LJXUH 5HPRYLQJ WKH )URQW %H]HO
While pressing the tab release, tilt the bezel away from the chassis, disengage the
two retaining hooks at the bottom of the bezel, and carefully pull the bezel away from
the chassis.
To replace the bezel, fit the two retaining hooks on the bezel into their corresponding
slots at the bottom of the chassis. Then rotate the top of the bezel toward the chassis
until the top tabs snap into their corresponding slots on the bezel.
5HPRYLQJDQG5HSODFLQJ)URQW3DQHO
,QVHUWV
Empty drive bays contain a front-panel insert to protect the inside of the computer
from dust particles and also to ensure proper airflow within the computer. Before you
install a drive in an empty drive bay, you must first remove the front-panel insert.
To remove the insert covering a 5.25-inch bay
, follow these steps:
7XUQ RII WKH V\VWHP LQF OXGLQJ DQ\ DWWDFKHG SHULSKHUDOV DQG GLVFRQQHFW
DOO WKH $& SRZHU FDEOHV IURP WKHLU SRZHU VRXUFH V
5HPRYH WKH FRPSXWHU FRYHU D V LQVWUXFWHG LQ ´5HPRYLQJ WKH &RPSXWHU
&RYHUµ LQ &KDSWHU
5HPRYH WKH IURQW EH]HO XVLQJ WKH LQVWUXFWLRQV LQ WKH SUHYLRXV VHFWLRQ
´5H PRYLQJ DQG 5HSODFLQJ WKH )URQ W %H]HOµ
tab release
retaining hooks (2)
23205BK0.BK : 23205100.FM Page 3 Wednesday, March 18, 1998 1:51 PM
Downloaded from www.Manualslib.com manuals search engine