Owners Manual

b) Peel the tape that secures the display-cable bracket to the system board [2].

c) Remove the two screws (M1.6x1.8) that secure the display-cable bracket to the system board and lift the bracket off the system

board [3].

d) Using the pull tab, disconnect the display cable from the system board [4].

e) Open the latch and disconnect the keyboard-back light cable from the system board [5].

f) Open the latch and disconnect the fingerprint-reader cable from the system board [6].

NOTE: Removing the coin-cell battery resets the BIOS setup program's settings to default. It is recommended

that you note the BIOS setup program's settings before removing the coin-cell battery.

g) Disconnect the coin-cell battery cable from the system board [7].

h) Remove the three screws (M2x4) that secure the Type-C USB bracket to system board and lift the bracket off the system board

[1].

i) Remove the two screws (M2x3) that secure the system board to the palm-rest and keyboard assembly [2].

j) Lift the system board off the palm-rest assembly [3].

Removing and installing components