Service Manual
Installing the Speakers
1 Using the alignment posts, place the speakers on the palm-rest assembly.
2 Replace the M2x2 (4) screws that secure the speakers to the palm-rest assembly.
3 Route the speaker cables through the routing guides on the palm-rest assembly.
4 Connect the speaker cable to the system board.
5 Install the:
a battery
b base cover
6 Follow the procedures in After Working Inside Your Computer.
Hard drive
Removing 2.5 inch Hard Drive -optional
1 Follow the procedures in Before Working Inside Your Computer.
2 Remove the:
a base cover
b battery
NOTE
: System shipped with 3-Cell battery, the hard drive will be part of the conguration
(Optional).
3 Perform the following steps to remove the hard-drive bracket from the computer:
a Remove the M2x4 (4) screws securing the hard-drive bracket to the computer [1].
b Lift the hard-drive cage [2] o the hard drive assembly [3].
Disassembly and reassembly
17