Service Manual

a Battery
b Base cover
7 Follow the procedures in After Working Inside Your Computer.
Display Assembly
Removing the Display Assembly
1 Follow the procedures in Before Working Inside Your Computer.
2 Remove the:
a base cover
b battery
3 Perform the following steps:
a Release the Mylar tape that secures the display cable to the system board [1].
b Lift the latch and disconnect the display cable from the connector on the system board [2].
c Release the Mylar tape that secures the display cable to the system board [3].
d Remove the M2x4 (2) screws and lift the metal bracket that holds the left video-card fan to the system board [4].
e Un-route the display cable from the restraints clips [5]
f Disconnect the display cable from the system board [6].
4 To remove the display assembly:
a Place the computer at the edge of a at surface and remove the M2.5x5 (6) screws securing the display assembly to the
system chassis [1].
b Lift the display assembly away from the system chassis [2].
34
Disassembly and reassembly