Owners Manual
Table Of Contents
- Precision 5720 All-in-One Owner’s Manual
- Working on your computer
- Removing and installing components
- USB dongle-bay cover
- Back cover
- Memory module
- Hard drive
- System board shield
- M.2 PCIe SSD
- Memory fan
- Heat sink
- Processor
- Coin cell battery
- WLAN card
- Stand
- System fan
- Power supply unit
- Inner frame
- Built-in self test button
- Microphone
- I/O panel
- USB-dongle port
- Diagnostic light and button board
- Drive cage
- Converter board
- Speaker
- Power button board
- Media card reader
- Camera
- System board
- Display assembly
- Middle frame
- Speaker bezel
- Display panel
- Technology and components
- System setup
- Software
- Troubleshooting
- Technical specifications
- System specifications
- Memory specifications
- Video specifications
- Audio specifications
- Communication specifications
- Connectors
- Display specifications
- Storage specifications
- Port and connector specifications
- Power specifications
- Camera specifications
- Stand specifications
- Physical specifications
- Environmental specifications
- Contacting Dell
After working inside your computer
After you complete any replacement procedure, ensure that you connect any external devices, cards, and cables before turning on your
computer.
1 Replace the cover.
CAUTION: To connect a network cable, rst plug the cable into the network device and then plug it into the
computer.
2 Connect any telephone or network cables to your computer.
3 Connect your computer and all attached devices to their electrical outlets.
4 Turn on your computer.
5 If required, verify that the computer works correctly by running ePSA diagnostics.
12 Working on your computer