Owners Manual

Steps

1. Disconnect the battery cable from the system board, if it was not disconnected earlier.

2. Remove the seven screws (M2x4) that secure the solid-state drive thermal bracket and the battery to the palm-rest and keyboard

assembly.

NOTE:

The two screws (M2x4) that secure the top of the battery also secure the solid-state drive thermal brackets

to the system board.

3. Lift the battery off the palm-rest and keyboard assembly.

Installing the battery

Prerequisites

About this task

The following image indicates the location of the battery and provides a visual representation of the installation procedure.

Disassembly and reassembly