Owners Manual

Steps

1. Connect the battery cable to the connector in the battery.

2. Place the battery onto its slot in the computer.

3. Replace the three (M2x5) screws to secure the battery to the computer.

Next steps

1. Install the base cover.

2. Install the SD card.

3. Follow the procedure in after working inside your computer.

ソリッドステートドライブ

Removing the primary M.2 Solid-state drive

Prerequisites

NOTE: For computers shipped with M.2 2280 or 2230 SSD installed in slot 3, slot 4, and/or slot 5.

1. Follow the procedure in before working inside your computer.

2. Remove the SD card.

3. Remove the base cover.

About this task

The figure indicates the location of the primary M.2 SSD and provides a visual representation of the removal procedure.

分解および再アセンブリ