Owners Manual

2. Install the SD card.

3. Follow the procedure in after working inside your computer.

WWAN カード

Removing the WWAN card

Prerequisites

1. Follow the procedure in before working inside your computer.

2. Remove the SD card.

3. Remove the base cover.

About this task

The figure indicates the location of the WWAN card and provides a visual representation of the removal procedure.

Steps

1. Loosen the (M2x3) screw that secures the WWAN card bracket to the system board.

2. Lift the WWAN card bracket from the WWAN card.

3. Disconnect the antenna cables from the connector on the WWAN card.

4. Slide and remove the WWAN card from its slot on the system board.

Installing the WWAN card

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The figure indicates the location of the WWAN card and provides a visual representation of the installation procedure.

Steps

1. Align and slide the WWAN card to its slot on the system board.

分解および再アセンブリ