Owners Manual

Steps

1. Align and place the SD care reader with its slot on the palmrest.

2. Replace the (M2.5x2.5) screw to secure the SD card reader to the palmrest.

3. Connect the LED board cable to the SD card reader on the bottom side of the computer.

4. Connect the SD card reader cable to the connector on the system board.

Next steps

1. Install the inner frame.

2. Install the WLAN card.

3. Install the WWAN card.

4. Install the primary M.2 SSD.

5. Install the inner frame.

6. Install the battery.

7. Install the base cover.

8. Install the SD card.

9. Follow the procedure in after working inside your computer.

電源ボタン

Removing the power button

Prerequisites

1. Follow the procedure in before working inside your computer.

2. Remove the SD card.

3. Remove the base cover.

4. Remove the battery.

5. Remove the heat-sink assembly.

6. Remove the power button board.

About this task

The figure indicates the location of the power button and provides a visual representation of the removal procedure.

分解および再アセンブリ