Owners Manual

Steps

1. Place the power button into its slot on the computer.

2. Replace the two (M2x3) screws to secure the power button in place.

Next steps

1. Install the power button board.

2. Install the heat-sink assembly.

3. Install the battery.

4. Install the base cover.

5. Install the SD card.

6. Follow the procedure in after working inside your computer.

指紋認証リーダー内蔵電源ボタンアセンブリー

Removing the power button assembly with fingerprint

reader

Prerequisites

1. Follow the procedure in before working inside your computer.

2. Remove the SD card.

3. Remove the base cover.

4. Remove the battery.

5. Remove the heat-sink assembly.

6. Remove the power button board assembly with fingerprint reader.

About this task

The figure indicates the location of the power button and provides a visual representation of the removal procedure.

Steps

1. Remove the two (M2x3) screws that secure the power button assembly with fingerprint reader in its slot on the computer.

2. Remove the power button assembly with fingerprint reader from the computer.

分解および再アセンブリ