Owners Manual

Installing the power button assembly with fingerprint

reader

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The figure indicates the location of the power button and provides a visual representation of the installation procedure.

Steps

1. Place the power button assembly with fingerprint reader into its slot on the computer.

2. Replace the two (M2x3) screws to secure the power button assembly with fingerprint reader in place.

Next steps

1. Install the power button board assembly with fingerprint reader.

2. Install the heat-sink assembly.

3. Install the battery.

4. Install the base cover.

5. Install the SD card.

6. Follow the procedure in after working inside your computer.

GPU 電源ケーブル

Removing the GPU power cable

Prerequisites

1. Follow the procedure in before working inside your computer.

2. Remove the SD card.

3. Remove the base cover.

4. Remove the battery.

分解および再アセンブリ