CLI Guide

BIOS.IntegratedDevices.EmbNicPort3BootProto (Read or Write)
Description
This is a Write-Only attribute to control the Legacy Boot Protocol of the LOM Port specified by the
Embedded NIC port number. This attribute is for system management software use, and does not appear
in System BIOS Setup. This attribute always returns Unknown when read. There is no change to the LOM
Port Legacy Boot Protocol setting when Unknown is written. An error is returned if written with a setting
(None, PXE, or iSCSI) that is not supported by the LOM Port.
Legal Values
● Unknown
● None
● Pxe
● Iscsi
Default Value Not Applicable
Write Privilege Server Control
License Required iDRAC Express or iDRAC Enterprise
Dependency Not applicable
BIOS.IntegratedDevices.EmbNicPort4BootProto (Read or Write)
Description
This is a Write-Only attribute to control the Legacy Boot Protocol of the LOM Port specified by the
Embedded NIC port number. This attribute is for system management software use, and does not appear
in System BIOS Setup. This attribute always returns Unknown when read. There is no change to the LOM
Port Legacy Boot Protocol setting when Unknown is written. An error is returned if written with a setting
(None, PXE, or iSCSI) that is not supported by the LOM Port.
Legal Values
● Unknown
● None
● Pxe
● Iscsi
Default Value Not Applicable
Write Privilege Server Control
License Required iDRAC Express or iDRAC Enterprise
Dependency Not applicable
BIOS.IntegratedDevices.EmbVideo (Read or Write)
Description
Enables or disables the use of the Embedded Video Controller as the primary display. When set to
Enabled, the Embedded Video Controller will be the primary display even if add-in graphics cards are
installed. When set to Disabled, an add-in graphics card will be used as the primary display. BIOS will
output displays to both the primary add-in video and the embedded video during POST and pre-boot
environment. The embedded video will then be disabled right before the operating system boots. Note:
When there are multiple add-in graphics cards installed in the system, the first card discovered during PCI
enumeration is selected as the primary video. You may have to re-arrange the cards in the slots in order
to control which card is the primary video controller.
Legal Values
● Enabled
● Disabled
Default Value Not Applicable
Write Privilege Server Control
License Required iDRAC Express or iDRAC Enterprise
Dependency Not applicable
144 BIOS Attributes