Owners Manual

Table 5. General options (continued)
Option Description
UEFI Boot Path Security
Allows you to control whether the system prompts the user to
enter the Admin password when booting to a UEFI boot path.
Click one of the following options:
● Always, Except Internal HDD—Default
● Always
● Never
System configuration
Table 6. System Configuration
Option Description
Integrated NIC Allows you to configure the integrated network controller. The
options are:
● Enable UEFI Network Stack
● Disabled
NOTE: You can use the Disabled option, only if Active
Management Technology (AMT) option is disabled.
● Enabled
● Enabled w/PXE (Default)
Integrated NIC 2 Allows you to configure the integrated network controller. The
options are:
● Enabled (Default)
● Enabled w/PXE
NOTE: This feature is supported only on Tower 7920.
UEFI Network Stack
Allows pre-OS and early OS networking features to use any
enabled NICs.
● Enabled UEFI Network Stack
This option is set by default.
Serial Port Identifies and defines the serial port settings. You can set the
serial port to:
● Disabled
● COM1 (Default)
● COM2
● COM3
● COM4
NOTE: The operating system may allocate resources even
if the setting is disabled.
SATA Operation
7920 Tower Allows you to configure the internal SATA hard-drive
controller. The options are:
● Disabled
● AHCI
● RAID-On (Default)
NOTE: SATA is configured to support RAID mode.
Drives
System Setup 101