Owners Manual
Table Of Contents
- Dell Precision 7920 Tower Owner's Manual
- Contents
- Chassis
- Working on your computer
- Removing and installing components
- Screw size list
- Recommended tools
- Power supply unit (PSU)
- Side cover
- Air shroud
- Front bezel
- PCIe holder
- Intrusion switch
- Front system fan assembly
- Internal chassis speaker
- Hard disk drive and the Optical disk drive bezel
- Hard disk drive assembly
- NVMe Flexbay
- Front input and output bezel
- Front input and output panel
- Rear system fan
- Right side cover
- Hard disk drive and optical disk drive frame
- Slim Optical Disk Drive
- 5.25-inch optical drive
- Power distribution and fan control board
- Front HDD cable and fan assembly
- Fan bracket
- Graphical processing unit(GPU)
- Memory
- Coin cell battery
- Processor heat sink module
- System board
- RAID controller battery
- VROC module
- Technology and components
- System specifications
- System Setup
- Software
- Troubleshooting
- Contacting Dell
3. Replac the two side screws and the central screw.
4. To install the SSD carrier slide the carrier in the NVMe flexbay until it clicks in place.
5. Slide the carrier into the drive bay until it clicks into place.
CAUTION: Ensure that the latch is open before installing the carrier.
6. Lock the latch.
7. Install the following components:
a. HDD bezel
b. side cover
8. Follow the procedure in After working inside your computer.
Front input and output bezel
Removing the front input and output bezel
1. Follow the procedure in Before working inside the computer.
2. Remove the:
a. side cover
b. front bezel
c. HDD and ODD bezel
3. To remove the front Input/Output (I/O) bezel, pry the edges of the panel [1].
Removing and installing components
43