Owners Manual
Table Of Contents
- Dell Precision 7920 Tower Owner's Manual
- Contents
- Chassis
- Working on your computer
- Removing and installing components
- Screw size list
- Recommended tools
- Power supply unit (PSU)
- Side cover
- Air shroud
- Front bezel
- PCIe holder
- Intrusion switch
- Front system fan assembly
- Internal chassis speaker
- Hard disk drive and the Optical disk drive bezel
- Hard disk drive assembly
- NVMe Flexbay
- Front input and output bezel
- Front input and output panel
- Rear system fan
- Right side cover
- Hard disk drive and optical disk drive frame
- Slim Optical Disk Drive
- 5.25-inch optical drive
- Power distribution and fan control board
- Front HDD cable and fan assembly
- Fan bracket
- Graphical processing unit(GPU)
- Memory
- Coin cell battery
- Processor heat sink module
- System board
- RAID controller battery
- VROC module
- Technology and components
- System specifications
- System Setup
- Software
- Troubleshooting
- Contacting Dell
b. Lift the coin-cell battery out of the system board.
Installing the coin cell battery
1. Place the coin-cell battery into its slot on the system board.
2. Press the coin-cell battery with positive (+) side facing up until the release latch springs back into place and secures it to the
system board.
3. To install:
a. air shroud
b. graphical processing unit (GPU)
c. side cover
4. Follow the procedure in After working inside your computer.
Processor heat sink module
Removing the processor heat sink module
1. Follow the procedure in Before working inside your computer.
74
Removing and installing components