Owner's manual

Installing the Network Connector

1. Align the network connector to its position on the computer.

2. Place the network-connector bracket on the network connector.

3. Tighten the screw to secure the network-connector bracket to the computer.

4. Route the cable through the routing channel.

5. Connect the cable to the system board.

6. Install:

a. base-corner cover (left)

b. base cover

c. battery

7. Follow the procedures in After Working Inside Your Computer.

Removing the Coin-Cell Battery

1. Follow the procedures in Before Working Inside your computer.

2. Remove:

a. battery

b. base cover

3. Disconnect the coin-cell battery cable, pry the coin-cell battery upward, and remove the coin-cell

from the computer.