Service Manual

Installing the RGB Display Panel

1. Align the display bracket with the display panel and tighten the screws

securing the display bracket in place.

2. Connect the Low-voltage Differential Signaling (LVDS) cable to the back of

the display panel and replace the adhesives securing the LVDS cable in

place.

3. Connect the RGB cable to the back of the display panel and replace the

adhesives securing the RGB cable in place.

4. Tighten the screws securing the display panel in place.

5. Tighten the screws on the left side of the display panel securing the display

panel in place.

6. Install the

touch screen display bezel

7. Install the

battery

8. Follow the procedures in

After Working Inside Your Computer

Removing The Touchscreen Display Panel

1. Follow the procedures in

Before Working On Your Computer

2. Remove the

battery

3. Remove the

touchscreen display bezel

4. Remove the screws on the left side securing the display panel in place. The

screws are partially hidden by the cables. Lift up the cables before

removing the screws.